15/16S -50A-P10-P1.0 specification

充电

Charge

过充电保护电压（单体）

Overcharge protection voltage (Cell)

3.70V

1-2S

1.放电电流>1A或

2.电压降至3.33V

1. Discharge current > 1A or

2. Voltage drop to 3.33V

过充电告警电压（整组）

Overcharge warning voltage (Pack)

58.0V

1.放电电流>1A或

2.电压降至56V

1. Discharge current > 1A or

2. Voltage drop to 56V

过充电保护电压（整组）

Overcharge protection voltage (Pack)

58.4V

1-2S

1.放电电流>1A或

2.电压降至53.28V

1. Discharge current > 1A or

2. Voltage drop to 53.28V

充电电流

Charging current

>55A

1-2S

1.检测到充电电流超过了保护值，且延时时间到后还过流，转入限流充电；

1. It was detected that the charging current exceeded the protection value, and the delay time was over-current, which was transferred to current-limiting charging.

2.限流充电180秒后，转不限流充电；

2. After 180 seconds of current-limiting charging, turn to non-current-limiting charging.

3.电池电压低于45V时，限流充电；

3. When the battery voltage is lower than 45V, current-limiting charging is needed.

放电

Discharge

过放电保护电压（单体）

Over discharge protection voltage (Cell)

2.7V

1-2S

1.充电电流>1A

2.所有单体电压升至3.0V

1. Charging current > 1A

2. All monomer voltages rise to 3.0V

过放电保护电压（整组）

Overdischarge protection voltage (Pack)

43.2V

1-2S

1.充电电流>1A

整组电压升至46.4V

1. Charging current > 1A

Voltage rise to 46.4V

放电过电流保护1

Discharge overcurrent protection 1

>60A

1-2S

充电电流>0.5A或

保护60秒后自动解除

Charging current > 0.5A or

Automatic Release of Protection after 60 seconds

短路保护

Short circuit protection

>200A

100uS

1.充电电流>0.5A或

2.保护60秒后

1. Charging current > 0.5A or

2. After 60 seconds of protection

温度保护

Temperature protection

放电时温度低于-15℃或高于55℃

充电时温度低于-5℃或高于50℃

The discharge temperature is below - 15 C or higher than 55 C.

Charging temperature is lower than - 5 C or higher than 50 C

1-2S

放电时温度高于-10℃且低于50℃恢复充电时温度高于0℃且低于45℃恢复

When discharging, the temperature is higher than - 10 and lower than 50 when recharging, the temperature is higher than 0 and lower than 45 when recharging.

PCB温度高于95℃

PCB temperature higher than 95℃

1-2S

低于75℃恢复

Recovery below 75℃